What Is Paintball.com Since 2002

2003 Shocker Trigger Job

Adjusting the 2003 Shocker trigger.

Like your 03’ Shocker but hate the trigger? Here is a quick guide to Make your trigger Insanely Awesome.

First, looking at the trigger from the Vertical regulator or gas through (after you have removed it) adjust the screw second from the bottom all the way out, don’t remove the screw but give it a good amount of turns. Next, using the bottom screw and screw on top of the trigger (looks like it’s actually in the frame ) Adjust the trigger to where the length of the pull is how you like it.

Do not worry about how “hard” the trigger pull is at this moment, we will get to that in a bit

Now… turn your gun on adjust that middle screw you adjusted at the beginning of the guide until it activated the micro switch (when the gun clicks), now back it out until You have it where you like it to shoot (at the beginning or end of a trigger pull) Do not have the trigger activate at the beginning of a trigger pull w/ a Long trigger pull, this risk’s damaging the micro switch

One you have the trigger the length you have it, now is the time to adjust how Stiff or Soft it is. This next step involves working w/ the Board inside the trigger frame, if you feel uncomfortable in doing this, bring it to a local shop to have it done.

To adjust the Amount of force needed to pull the trigger, we must remove the board to gain access to the Magnet inside the trigger frame. First remove your Grips and battery. Next, remove the 2 pins right behind the trigger holding the board in and slide it out. DO NOT LOSE THESE PINS!. Next, Using an Allen wrench, move the small magnet near the bottom of the grip frame closer or father away from the Trigger Closer=Harder trigger pull, Farther = softer You can remove the magnet all the way if you wish, but this might cause the gun to have Trigger bounce. which is illegal at most fields and tournaments. Once you have Adjusted the trigger how you like it, Replace the board and put the pin back in, then replace the battery and Grips. Then reattach your Vertical regulator or gas through and Go shoot some paint cause now you got a Pimp Trigger